How to use pads in worship
A pad is a soft, held sound in the key of the song. It sits under the band, carries the gaps between songs and holds the room during prayer. You don't need a keys player to use one. A phone and a cable to the desk will do.
Try it as you read
The free Taiao pad. Tap a key, press play.
Taiao · free · key of D
Open the full player in DWhat a worship pad is
A pad is a long, sustained sound that holds one key and barely moves. No beat, no melody. Keys players have done this for years by holding a soft synth chord under the band. A recorded pad does the same job with nobody playing it: you press play in the right key and it holds for as long as you need.
Because it has no rhythm, it can't drift out of time with the band. The only thing it can get wrong is the key.
What it does for your set
- Fills out a thin sound. One acoustic guitar or a piano on its own leaves a lot of empty space underneath. A pad fills it, and most people won't notice a new instrument, just a fuller room.
- Holds the gaps. Retuning, moving a capo, reading a verse, someone walking up to the mic. The room stays where it was instead of dropping into silence.
- Carries prayer and response. The band can stop and the pad holds on its own. More on that in pads for prayer and ministry time.
- Joins songs together. Two songs in the same key? Leave the pad running and go straight from one into the next.
1. Pick the key
The pad goes in the key of the song. The chart usually says it at the top. If it doesn't, it's normally the chord the song starts and finishes on.
- Capo. Count up from the shapes. G shapes with a capo on 2 is the key of A, so the pad goes on A.
- Flat keys. The player names the black notes as sharps: Bb is A#, Eb is D#, Ab is G#, Db is C#, Gb is F#.
- Minor key songs. Use the pad in the relative major, not the root. A song in E minor gets the G pad. There's a chart for every key in worship pads for minor key songs.
- Not sure? Hold the pad under the first chord at rehearsal. If it sounds sour, it's the wrong key.
2. Get it into the room
Run a cable from the phone, tablet or laptop headphone out into two line inputs on the desk, or into a stereo DI box. A phone speaker won't fill a church. Turn on Do Not Disturb so a text doesn't go through the PA, and turn on Stage Mode: it shows a big key you can read from the mic and keeps the screen awake while the pad plays.
Setting up on a phone? See worship pads on iPhone and Android. Running slides too? See pads with ProPresenter.
3. Set the level
The pad belongs under the band. People should feel it more than hear it. Set it at soundcheck with the whole band playing, because a pad that sounds right on its own is nearly always too loud in the full mix.
The player has no volume slider, so pick one device volume (around 80% is a good start) and use it every week. Then the pad fader means the same thing every Sunday.
4. Know when to play it
- Before the first song. Start it low during the welcome, in the key of your opener. The band comes in over the top and there's no cold start.
- Under the songs. Leave it running. It's doing its job even when you can't pick it out.
- Between songs. This is where it earns its place.
- Prayer, communion and response. Bring the band down and let the pad hold on its own, a touch louder than under the songs.
- Moments that want silence. A bare first verse or an a cappella chorus can land harder with nothing under it. It's fine to stop.
- Handing over to the preacher. Pull the fader down slowly under their first few words. Pressing pause stops the pad straight away, which can sound abrupt.
5. Change keys between songs
Tap the next song's key. On a laptop or an Android phone the new key fades in over the old one across a couple of seconds, so you can change while the last chord is still ringing. On iPhone and iPad the change is instant, so wait until the last chord has died away or someone is talking, or dip the volume, tap, and bring it back up.
- Plan the set so neighbouring songs share a key, or sit a step apart. Fewer changes, smoother set.
- Use Setlist link in the player: tap your keys in order and it makes a link. Open it on the stage device and Stage Mode shows only your set's keys, as big numbered buttons.
- Each key also has its own page with the chords and capo shapes, for example worship pad in D or worship pad in G.
Common mistakes
- Too loud. By far the most common one. Turn it down until you almost miss it.
- Wrong key after a capo change. The guitarist moved the capo and the pad didn't follow. Ask at rehearsal.
- A root pad under a minor song. It clashes. Use the relative major.
- A notification through the PA. Do Not Disturb, every week.
- Leaving it under the sermon. Bring it down as the preacher starts unless they've asked for it.
Questions
What is a pad in worship?
A pad is a soft, sustained sound held in the key of the song. It plays under the band, fills the gaps between songs and holds the room during prayer. It has no beat or melody, so it can't drift out of time.
What key should the worship pad be in?
The key of the song you're playing. With a capo, count up from the shapes: G shapes with a capo on 2 is the key of A. For a minor key song, use the relative major, so a song in E minor gets the G pad.
Do I need a keyboard player to use pads?
No. A recorded pad holds the key by itself. Open the Online Pad Player on a phone, tablet or laptop, pick the key, press play and run a cable to the sound desk.
How loud should pads be in worship?
Under the band. People should feel it more than hear it. Set the level at soundcheck with the full band playing, because a pad that sounds right on its own is almost always too loud in the mix.
Pick the key of your first song and press play. You'll hear the difference straight away.
Open the pad player